GE Industrial Solutions AF-600 FP Metasys - Manual (Page 22)

3 Appendix
3.1.1 Analog Inputs (AI)
NPT NPA UNIT DESCRIPTION RANGE PAR.NUMBER
AI 0 % Reference [%] - DR-02
AI 1 - Reference [Unit] - DR-01
AI 2 - Feedback - DR-52
AI 3 Hz Frequency - DR-13
AI 4 - User defined readout - DR-09
AI 5 A Current - DR-14
AI 6 kW Power - DR-10
AI 7 hp Power - DR-11
AI 8 V Output Voltage - DR-12
AI 9 V DC Voltage - DR-30
AI 10 % Motor Thermal Protection - DR-18
AI 11 % Inverter Thermal Protection - DR-35
AI 12 V Terminal 53 analog - DR-62
AI 13 V Terminal 54 analog - DR-64
AI 14 Reserved -
AI 15 Reserved -
AI 16 % External reference - DR-50
AI 17 C Heat sink temperature - DR-34
AI 18 Hour Operating hours - ID-00
AI 19 Hour Running hours - ID-01
AI 20 kWh kWh counter - ID-02
AI 21 - Number of Power-ups - ID-03
AI 22 - Number of Over temps - ID-04
AI 23 - Number of Over voltages - ID-05
AI 24 Start Ups ID-08
AI 25 Torque [%] DR-22
AI 26 Speed [rpm] DR-17
AI 27 Analog Input, GPIO X30/11 DR-75
AI 28 Analog Input, GPIO X30/12 DR-76
AI 29 Analog Input X42/1 -20.000 to +20.000 LG-30
AI 30 Analog Input, X42/3 -20.000 to +20.000 LG-31
AI 31 Analog Input, X42/5 -20.000 to +20.000 LG-32
AI 40 Bypass Running Hours 0-2 32 /10 BP-11
The default values are shown in bold on the following pages. Any point not listed on the following pages is reserved for future use.
Some Metasys software uses an object number range from 0 to 255, other Metasys software uses the range 1 to 254. The latter software will interpret object
number 0 as 1, and 1 as 2, etc. To access the proper point with this Metasys software, add 1 to the NPA number in the tables.
AF-600 FP Metasys
21
3