GE Industrial Solutions AF-650 GP PROFINET - Manual (Page 7)

3 How to Install
3.1.1 How to Install Option in Frequency
Converter
Items required for installing a network option in the
frequency converter:
- The network option
- Network option adaptor frame for the AF-600 FP/
AF-650 GP. This frame is deeper than the
standard frame, to allow space for the network
option beneath
- Strain relief (only for unit sizes 11 and 12)
Illustration 3.1
Illustration 3.2
Instructions:
- Remove keypad panel from the AF-600 FP/AF-650
GP.
- Remove the frame located beneath and discard it.
- Push the option into place. The Ethernet
connectors must be facing upwards.
- Remove both knock-outs on the network option
adaptor frame.
- Push the network option adaptor frame for the
AF-600 FP/AF-650 GP into place.
- Replace the keypad and attach cable
NOTE
Do not strip the Ethernet cable and ground it via the strain
relief-plate! The grounding of screened Ethernet cable is
done through the RJ-45 connector on the option.
NOTE
After installing the OPCPRT option, be aware of the
following parameter settings:
O-01 Control Site: [2] Controlword only or [0] Digital and ctrl.
word
O-02 Control Word Source: [3] Option A
How to Install PROFINET Operating Instruction
6
3 3