GE Industrial Solutions AF-650 GP PROFINET User Manual
Page 42
Bit
Condition when bit is active
0
Connection with IO Controller is not ok
1
Reserved for status of connection with second IO
Controller
2
Not used
3
Clear data command received
4
Actual value is not updated
5
No Link on both port
6
Not used
7
Initializing of PROFINET is not ok
8
Drive is tripped
9
Internal CAN error
10
Wrong configuration data from IO Controller
11
Not used
12
Internal error occurred
13
Not configured
14
Timeout active
15
Warning 34 active
Table 8.1
PB-65 Profile Number
Range:
Function:
0 N/A
*
[0 - 0 N/A] This parameter contains the profile identifi-
cation. Byte 1 contains the profile number
and byte 2 the version number of the
profile.
NOTE
This parameter is not visible via keypad.
PB-70 Edit Set-up
Option:
Function:
Select the set-up to be edited.
[0]
Factory setup Uses default data. This option can be used
as a data source to return the other set-ups
to a known state.
[1]
Set-up 1
Edits Set-up 1.
[2]
Set-up 2
Edits Set-up 2.
[3]
Set-up 3
Edits Set-up 3.
[4]
Set-up 4
Edits Set-up 4.
[9]
*
Active Set-up Follows the active set-up selected in
K-10 Active Set-up.
This parameter is unique to keypad and fieldbuses. See
also K-11 Edit Set-up.
PB-71 Profibus Save Data Values
Option:
Function:
Parameter values changed via PROFINET are
not automatically stored in non-volatile
memory. Use this parameter to activate a
function that stores parameter values in the
PB-71 Profibus Save Data Values
Option:
Function:
EEPROM non-volatile memory, so changed
parameter values will be retained at power-
down.
[0]
*
Off
Deactivates the non-volatile storage function.
[1]
Store all
setups
Stores all parameter values for all set-ups in the
non-volatile memory. The selection returns to
Off [0] when all parameter values have been
stored.
[2]
Store all
setups
Stores all parameter values for all set-ups in the
non-volatile memory. The selection returns to
Off [0] when all parameter values have been
stored.
PB-72 ProfibusDriveReset
Option:
Function:
[0]
*
No action
[1]
Power-on reset
Resets frequency converter upon power-
up, as for power-cycle.
[2]
Power-on reset
prep
[3]
Comm option
reset
Resets the PROFINET option only, the
PROFINET option will go through a
power-up sequence.
When reset, the frequency converter
disappears from the Network, which may
cause a communication error from the
master.
PB-80 Defined Parameters (1)
Array [116]
No keypad access
Read only
Range:
Function:
0 N/A
*
[0 - 9999 N/A] This parameter displays a list of all the
defined frequency converter parameters
available for PROFINET.
PB-81 Defined Parameters (2)
Array [116]
No keypad access
Read only
Range:
Function:
0 N/A
*
[0 - 9999 N/A] This parameter displays a list of all the
defined frequency converter parameters
available for PROFINET.
Parameters
PROFINET Operating Instruction
41
8
8