GE Industrial Solutions CAR2012TE series - Manual

GE Data Sheet
February 9, 2014 ©2013 General Electric Company. All rights reserved.
CAR2012TE series rectifier
Input: 85Vac to 264Vac; Output: 12Vdc @ 2000W; 3.3 @ 4A or 5Vdc @ 3A Standby
Features
 Efficiency: 95 % @ 50% load. Under most load conditions
exceeding 80plus “Titanium” criteria
 Universal input with PFC
 Constant power characteristic
 2 front panel LEDs: 1-input;2-[DC_OK, fault, warning]
 Remote ON/OFF control of the 12Vdc output
 Remote sense on the 12Vdc output
 No minimum load requirements
 Active load sharing (single wire)
 Hot Plug-ability
 Standby orderable either as 3.3Vdc @ 4A or 5Vdc @ 3A
 Auto recoverable OC & OT protection
 Operating temperature: -10 - 70C (de-rated above 50C)
 Digital status & control: PMBus serial bus
 EN/IEC/UL/CSA C22.2 60950-1 2 nd edition +A1, CCC
 CE mark§
 Meets FCC part 15, EN55022 Class A standards
 Meets EN61000 immunity and transient standards
 Shock & vibration: Meets IPC 9592 Class II standards
Applications

12Vdc distributed power architectures

Datacom and Telecom applications

Mid to high-end Servers

Routers/Switches

Broadband Switches

ATE Equipment
Description
The CAR2012TE Front-End provides highly efficient isolated power from worldwide input mains in a compact 1U
industry standard form factor. This power supply is ideal for applications where mid to light load efficiency is of key
importance in order to reduce system power consumption during ‘typical’ operational conditions.
The high-density, front-to-back airflow is designed for minimal space utilization and is highly expandable for future
growth. The industry standard PMBus compliant I 2 C communications buss offers a full range of control and
monitoring capabilities. The SMBAlert signal pin automatically alerts customers of any state change within the power
supply.
* UL is a registered trademark of Underwriters Laboratories, Inc.
† CSA is a registered trademark of Canadian Standards Association.
‡ VDE is a trademark of Verband Deutscher Elektrotechniker e.V.
§ Intended for integration into end-user equipment. All the required procedures for CE marking of end-user equipment should be followed. (The CE mark is placed on selected products.)
** ISO is a registered trademark of the International Organization of Standards.
+ PMBus name and logo are registered trademarks of the System Management Interface Forum (SMIF)