Chapter 11: using telnet, Onfiguration, Sing – B&B Electronics ESR904 - Manual User Manual
Page 71: Elnet
Using Telnet
Manual Documentation Number: ESR90x-5012m
Chapter 11
61
B&B Electronics Mfg Co Inc – 707 Dayton Rd - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
C
C
H
H
A
A
P
P
T
T
E
E
R
R
1
1
1
1
:
:
U
U
S
S
I
I
N
N
G
G
T
T
E
E
L
L
N
N
E
E
T
T
Telnet
can be used to configure the Serial Server from any PC on the LAN.
The
Telnet
window displays the same configuration information shown in
Console Mode
and allows server properties to be configured.
N
N
o
o
t
t
e
e
:
:
See Chapter 5 for details on Server Properties.
Configuration Using Telnet
Step 1: Ensure the PC and Serial Server are connected to the LAN.
Step 2: Apply power to the Serial Server. The power and ready LED will
light.
Step 3: Ensure Serial Server is in Run Mode. If the Run/Console switch is
in the Console position, switch it to the Run position. The Serial
Server will revert to the operational mode it was in before the switch
was set to Console.
Step 4: From the
Desktop
, click
Start
, then
Run.
The Run dialogue box will
open.
Step 5: Type in
Telnet
and the IP address of the Serial Server to be
configured, then click
OK
.
Figure 43. The Run dialogue box