Update/save – B&B Electronics ESR904 - Manual User Manual
Page 49

Server Properties Configuration
Manual Documentation Number: ESR90x-5012m
Chapter 5
39
B&B Electronics Mfg Co Inc – 707 Dayton Rd - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Update/Save
Server properties must be updated separately for each serial port. Updating
varies slightly depending on which of the four configuration user interfaces
are used.
Updating the Server Properties in ESP Manager
From the
Server Properties
screen, click the
Update
button to store the
configuration settings for the currently selected port. The vcomui dialogue
box will appear indicating you must restart the device before the new settings
will take effect. Click
Yes
. After several seconds a dialogue box will ask
whether you want to search for all reachable servers again. Click Yes.
After that port has been updated you may want to re-enter
Server Properties
to verify the changes have taken effect, or to view/change the configuration
of other ports. Each port must be configured separately.
Saving Configuration Data in Console Mode or Telnet
Saving (updating) server properties is done from the
Configuration
screen.
Access the
Configuration
screen by tabbing through the list of screens on the
left side of the window and highlighting
Configuration
.
There are four options shown on the right side of the
Configuration
screen:
Save
,
Default
,
Running
and
Reset
. Use
Tab
,
Backspace
, or
arrow
keys to
move the cursor to the option position, and then press
Enter
.
Save stores the configuration data to the Serial Server flash memory and
resets it.
Default restores the configuration data to factory default settings.
Running restores the configuration data to the last values stored in the
flash memory.
Reset re-boots the Serial Server, making it available for a client
connection.
Web Server Interface
The
Web Server
interface provides the same updating options as
Console Mode
and
Telnet
. These are located at the bottom of all three
Web Server
pages. If a field is changed, you must click
Save
before
leaving that page or the changes will be ignored.
N
N
o
o
t
t
e
e
:
:
If you leave any Web Server page without saving, any changes you have made
will be ignored.