M&C TechGroup MP-F10_R Operator's manual - Manual (Page 15)

10.1a-ME Gas sampling and gas conditioning technology 15

To prevent the maximum permissible operating pressure being exceeded, restriction or control
of the air or gas flow should only be carried out in the suction line.

If restriction or control of the air or gas flow is made on the pressure side ensure that the
maximum permissible operating pressure is not exceeded.

Diaphragm and valve plates are the only parts subject to wear. Wear is usually indicated by a
drastic reduction in the pneumatic performance. When replacing parts proceed as described in
section 14.
13 CLOSING DOWN
N O T E !
The area in which the pump is situated when it is not in use must
be kept free of frost at all times!
When decomissioning no particular measures need to be taken.
14 MAINTENANCE
Before the maintenance work is carried out, it is necessary that the specific safety procedures pertain-
ing to the system and operational process are observed!
W A R N I N G !
It is necessary to take the pump off the mains before any assembly,
maintenance or repair work is carried out!
W A R N I N G !
Aggressive medium is possible.
Wear protective glasses and proper protective clothing during
disassembly, repair or cleaning!
Bellows and valve plates are the only parts of the pump subject to wear. They are simple to change.
For our recommendations for spare parts please refer to the spare parts list in chapter 16.