EVS XTnano Version 10.03 - July 2010 Configuration Manual - Manual (Page 57)

Issue
10.03.D XTnano – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
50
GPI IN Settings p.8.3
GPI# Channel/Device Function
vious
r+F_]Dft [F9]PgUp [F0]PgDn
5[F1]RMT1 [F5]Pre
6[F2]RMT1 [F6]Next
7[F3]RMT1 [F7]Skip
8[F4]-------------- [F8]Pause
[Menu]Quit [Cl
fine the following
C
HANNEL
/D
EVICE
affect or the device that
device can be an EVS Remote #1. If the operator selects EVS Remote #1, the
I will trigger the selected action on all channels controlled by that Remote
nel.
UNCTION
previous clip inside the playlist), Next (go to next clip
inside the playlist), Skip (skip the next clip in the playlist), -------- (no action is
taken) or Tally. For more information on the possible functions, refer to the
age 4 of the Setup Configuration in Multicam.
For the pinout of the GPI connector and wiring instructions, please refer to the XT
anual.
3.14.3 GPI
S
IN D
ELAY
ngs p.8.4
GPI# Delay GPI# Delay
5[F5]Disable
2[F2]Disable 6[F6]Disable
8[F8]Disable
[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn
For each GPI input, the operator has the possibility to de
parameters:
This parameter specifies the channel that the GPI will
will send the GPI to the server.
A
GP
Pa
F
This parameter specifies the function that the GPI will trigger: Play, Pause,
Recue, Previous (recue to
explanation on p
Tech Ref Hardware m
GPI IN Setti
1[F1]Disable
3[F3]Disable 7[F7]Disable
4[F4]Disable
Possible values: Disable (default, immediate reaction), or 00s01fr to 02s00fr
This parameter defines the number of seconds and/or frames that the server will
wait after receiving the GPI IN signal to execute the GPI-related function.