EVS XTnano Version 10.03 - July 2010 Configuration Manual - Manual (Page 21)

Issue
10.03.D XTnano – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
14
UserBits Yes/No flag to specify if the user bits have to be inserted in the
output. The default value is ‘Yes’.
HANC VITC Field if embedded timecode has to be inserted in the to specify
e specified has to be the same as for the HANC
The possible values are:
No No new timecode inserted in the output.
In (default) Same timecode as in the input inserted in
the output.
LTC Timecode from the LTC table inserted in
the output.
USER User-defined timecode inserted in the
output.
output. The valu
LTC field.
SD OUT
D-VITC Field to specify if embedded timecode has to be inserted in the
output. The possible values are:
No No new timecode inserted in the output.
the output.
USER User-defined timecode inserted in the
output.
In (default) Same timecode as in the input inserted in
LTC Timecode from the LTC table inserted in
the output.
Lines Lines on which the specified timecode must be written on the loop
of the input.
By default, these are lines 14-16 in NTSC and 19-21 in PAL.
UserBits Yes/No flag to specify if the user bits have in the
o fa
to be inserted
utput. The de ult value is ‘Yes’.
Clean VBI Field in which the use specifies whether the VBI needs to be
c
d on the
No The VBI is not cleaned in the output.
Always I is always cleaned in the output.
ar mode, vertical split
screen, etc.)
leane output. The possible values are:
The VB
If not OK The VBI is cleaned in the output if it is not
correct (play v