EVS XTnano Version 10.03 - July 2010 Configuration Manual - Manual (Page 26)

XTnano – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.D
19
Setting Description
iates a command to exit the loop as soon
as possible without playing the current
d jump to the
playlists in IPDirector.
Initiates a command to exit the loop as soon
as the OUT point of the current element is
nt.
or.
Exit ASP Init
element until its end an
selected element. This GPI is used with
Exit OUT
reached and jump to the selected eleme
This GPI is used with playlists in IPDirect
None No value is defined.
GPI Delay
efault value is ‘disabled’.
Number of seconds and/or frames that the server will wait
after receiving the GPI IN signal to execute the GPI-related
function. The d
The following information is defined for each individual GPI OUT:
Setting Description
# GPI number
Function Operation that will
defined with the f
• Replace function
trigger the GPI OUT. The GPI OUT can be
ollowing function:
Type Type of GPI signal. Four types are possible:
Close-High The trigger is done when the
level changes to high level
Close-High
Pulse
The trigger is done on a rising
edge pulse
Open-Low The trigger is done when the
level changes to low level
Open-Low
Pulse edge pulse.
The trigger is done on a falling
GPI OUT
advance
Number of seconds and/or frames ahead of the timecode (on
w
is defined) corresponding to the time when the
GPI OUT will be sent by the server. The default value is
‘disabled’.
hich a GPI
GPI Pulse
Duration
The pulse duration needs to be defined for pulse signals.
The default value is ‘disabled’.