EVS XTnano Version 10.03 - July 2010 Configuration Manual - Manual (Page 35)

Issue
10.03.D XTnano – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
28
3. Setup from the
Remote Panel
3.1 INTRODUCTION
When you work in Sportlight mode, the Setup menu available on the nano Remote
Panel allows you to define parameters. The values assigned to the parameters are
saved as soon as they are assigned.
Important
playlists will not change. It is thus important to set these parameters
first.
Prior to using Multicam, the operator should enter the Setup menu and
set all necessary parameters. If clips are stored with certain parameters
and the operator wishes to change them afterwards, those clips and
3.2
ys and
small buttons
Multi-purpose keys
display, allows the operator to enter the
MENU system
erational
ck 1
See Multicam Operational manual for more information
onal See Multicam Operational manual for more information
7. LCD Display Provides current status of system
GENERAL LAYOUT
The following diagram shows the Remote Panel along with a brief description of
each area.
1. F-ke
2. Soft keys With LCD
Multicam
3. Lever Initiates slow motion and playlist replay
4. Jog dial Used to accurately cue disk recorder
5. Op
blo
6. Operati
block 2