EVS XTnano Version 10.03 - July 2010 Configuration Manual - Manual (Page 20)

XTnano – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.D
13
2.3.2 VITC/ANC M
ANAGEMENT IN
HD IN
AND
HD/SD OUT
e pag In HD, th e is as follows:
The following p rs can
IN LOOP
D-VITC and user bits are always written on the monitoring SD
outputs of the record codec and are the same as on the source
aramete be defined:
The TC
video.
Lines Lines on which the VITC must be written on the monitoring output
.
connectors of the record codec. By default, these are lines 14-16 in
NTSC and 19-21 in PAL
HD OUT
HANC LTC Field to speci inserted in the
output. value specified has to be the same as for the HANC
V . The
In (default) e timecode as in the input inserted in
the output.
LTC Timecode from the LTC table inserted in the
output.
USER User-defined timecode inserted in the
output.
fy if embedded timecode has to be
The
ITC field possible values are:
No No new timecode inserted in the output.
Sam