EVS XTnano Version 10.03 - July 2010 Configuration Manual - Manual (Page 40)

XTnano – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.D
33
3.8 ECORD TRAIN SETTINGS
[F3]Auto make clip for cam C : Yes
R
Record Trains p.2.1
[F1]Auto make clip for cam A : Yes
[F2]Auto make clip for cam B : Yes
[F6]Resync to TC ref
[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn
3.8.1
si
s f
corresponding to the camera on which IN/OUT points have been marked are
ay lly the same action independently
for each camera.
3.8.2
ESYNC TO
e
to
too important, a “!TC” warning appears on the OSD of the output monitors and the
uities by calling the Resync to TC ref function. This function
synchronizes the internal TC to the timecode read on the LTC input of the server.
m ode was continuous
for previously recorded material, and will take into account the new timecode
on
Note that the above explanation is only valid for record trains. For clips, the
ays assumed continuous inside the clip. Clearing the internal
TC table will consequently have no effect on the timecode of recorded clips.
To call the Resync to TC ref function, simply press the F6 key. The function is
immediately performed and the message “TC resynchronization done”
is displayed.
A
UTO MAKE CLIP FOR CAM
A/B/C
Pos ble values: Yes (default) / No
Thi unction selects the automatic camera creation. When creating clips, the clip
alw s saved. It is possible to save automatica
R TC
REF
The Multicam application uses an internal table to reference all timecod
discontinuities detected on the LTC input of the system. This table is used
match a recorded field to its timecode. When the number of TC discontinuities is
system switches to the “internal timecode mode”. The operator can clear the TC
discontin
Fro that moment on, the system will assume that the timec
disc tinuities.
timecode of the first field of the clip is memorized at the creation of the clip, and
the timecode is alw