AASTRA 4422 IP Office for MD Evolution User Guide - Manual (Page 106)

Programming Your Extension’s Services
MD Evolution – Dialog 4422 IP Office 106
í
Next, press the C (Clear or Erase) key on your extension to
end this service.
Your extension returns to idle status.
CALL-FWD
Ô
Your extension’s Call-fwd key has now been pre-
programmed. The call forwarding that you have just
programmed will only take effect when you press the Call-
fwd key. See the “
Call Forwarding Services ” section.
Note: The 61, 62, 63, 64 and 69 prefixes are usually used
to process the call forward service. They may, however,
have been modified by your system administrator.
Programming Your User Password
You will be prompted to enter your user password when accessing
certain services, most particularly:
•
When you log on to your extension or a third party set.
• When placing a call in substitution or with signature from your
extension or a third party set.
• When activating/deactivating a call forward from your extension
or a third party set (follow me service).
• When consulting or personalising your mailbox within your facility’s
integrated voice mail system, when applicable.
By default, your user password is “1234”. It is strongly recommended
that you change it to any other 4-digit code – including the * or #
key – to ensure that use of the aforementioned services is as secure
as possible, and to preserve the confidentiality of your mailbox,
when applicable.
To do so, from your idle extension:
79
z
Dial the prefix “79” assigned to the user password
management service.
OLD PSW
z
Next, enter your current user password.
NEW PSW
z
Then, enter your new user password.
Â
Press the Loudspeaker key on your extension.
You will receive both visible and audible confirmation for registering
your new password: “PASSWORD REGISTERED” will be displayed
on your screen, and the service acceptance tone will be played.