Garmin GPS 500 - Manual (Page 162)

GPS 500 Pilot’s Guide and Reference 8-28
SECTION 8
AUX PAGES
NOTE: The ‘Traffic’ selection in the Auxiliary
Configuration Field is only available if the GPS
500 is configured for interface with a traffic
information device (see Section 12).
3) Press the ENT Key to accept the data type.
4) If ‘Configurable Data Fields’ is selected, a
second selection field appears. Turn the large
right knob to highlight this second field, then
turn the small right knob to display a list of
available navigation data types (Table 8-3).
Continue turning the small right knob to
select the desired data type and press the ENT
Key to confirm the selection.
Abbreviation Data Type
BRG Bearing
CTS Course To Steer
DIS Distance
DTK Desired Track
ESA Enroute Safe Altitude
ETA Estimated Time of Arrival
FLOW Total Fuel Flow
GS Ground Speed
MSA Minimum Safe Altitude
TKE Track Angle Error
TRK Track
VSR Vertical Speed Required
WPT Active Waypoint
XTK Cross Track Error
Table 8-3
5) Press the small right knob to remove the cursor
and return to the Setup Page.
Restoring Factory Settings
When making changes to any Setup Page option, a
‘Restore Defaults?’ menu selection allows the pilot to
restore the original factory settings (for the selected option
only). For example, with the CDI/Alarms Page displayed,
the ‘Restore Defaults?’ option restores all airspace alarms
and CDI settings to the original factory values.
Restoring a Setup Page option to the
original factory settings:
1) Select the desired menu option from the
Setup Page, using the steps described at the
beginning of this section.
2) Press the MENU Key to display the CDI/Alarms
Page Menu (Figure 8-44).
Figure 8-44 CDI/Alarms Page Menu
3) With ‘Restore Defaults?’ highlighted, press the
ENT Key.
190-00181-60 Rev. G