Garmin GPS 500 - Manual (Page 100)

GPS 500 Pilot’s Guide and Reference 6-2
SECTION 6
WPT PAGES
Entering a waypoint identifier:
1) Select the desired WPT page and press the
small right knob to activate the cursor.
2) Turn the small right knob to select the first
character of the waypoint’s identifier.
3) Turn the large right knob to select the next
character field.
4) Turn the small right knob to select the desired
character (Figure 7-2).
Figure 6-2 Waypoint Identifier Selected
5) Repeat steps 3 and 4 until the identifier is
selected, then press the ENT Key.
6) To remove the flashing cursor, press the small
right knob.
Entering a waypoint facility name or city
location:
1) Select the Airport Location Page, NDB Page
or VOR Page from the WPT Page Group (as
described on the preceding page).
2) Press the small right knob to activate the
cursor.
3) Turn the large right knob to select the facility
name or location (city) field.
4) Turn the small right knob to select the desired
character (Figure 6-3).
Figure 6-3 Facility Location Field Selected
5) Turn the large right knob to select the next
character field.
6) Repeat steps 4 and 5 until the facility name or
location is selected, then press the ENT Key .
7) To remove the flashing cursor, press the small
right knob.
190-00181-60 Rev. G