Garmin GPS 500 - Manual (Page 146)

GPS 500 Pilot’s Guide and Reference 8-12
SECTION 8
AUX PAGES
If a ‘WARN’ annunciation appears at the bottom
left corner, GPS satellite coverage may be
sufficient, but the GPS 500 has detected a position
error which exceeds protection limits. In this
condition, all GPS navigation data on the GPS 500
is disabled. Use an alternate navigation source.
• Software Versions - Provides software version
information for the operating software within the
GPS receiver, and main processor board.
• Database Versions - Displays the current Jeppesen
database type and expiration date, along with the
version and type of built-in land database.
• Terrain Database Versions - Displays the current
version and area of coverage of each terrain and
obstacle database. If a database is found to be
missing and/or deficient, the TAWS system fails
the self-test and issues a failure message.
Utility Page: Checklists
Creating a checklist:
1) Select ‘Checklist’ from the Utility Page using
the steps described at the beginning of this
section (8.3). Press the ENT Key to display a
list of checklists.
2) Press the MENU Key to display the Checklist
Page Menu (Figure 8-18). Turn the large right
knob to select ‘Create New Checklist?’ and
press the ENT Key.
Figure 8-18 Checklist Page Menu
3) Use the small and large right knobs to enter
the name of a checklist. Press the ENT Key
when finished. (Up to nine different checklists
can be created and stored in the GPS 500.)
4) Use the small and large right knobs to enter
each checklist item, followed each time by the
ENT Key. Each checklist may contain up to 30
line items of as much as 16 characters long.
190-00181-60 Rev. G