3Com 1100 - Manual (Page 83)

Configuring the Stack 83
3 Click a port in the Available Ports listbox.
4 Click the Add >> button. The port is assigned to the port trunk, and the
port is displayed in the Trunk Members listbox.
There are several conditions that need to be satisfied before a port can be
placed in a port trunk. See
“Port Trunks and Your Switch” on page 158 .
To place a port back in the Available Ports listbox, click the port in the
Trunk Members listbox and click the << Remove button. The first
(primary) port cannot be placed back in the Available Ports listbox until
the other ports are placed back.
Configuring VLANs You can configure VLANs for the stack using the VLAN Setup page.
To access the page:
1 Click the Configuration icon on the side-bar.
2 Click the VLANs hotlink. The VLAN Setup page is displayed as shown in
Figure 22 .
Figure 22 The VLAN Setup page