3Com 1100 - Manual (Page 103)

A Quick Guide to the Commands 103
feature analyzer display Displays information about the roving analysis
port configured in the stack.
feature analyzer remove Removes the designated roving analysis port
from the current port.
feature analyzer start Specifies the roving analysis monitor port (that
is the port from which data will be copied) and
starts monitoring by the analysis port.
feature analyzer stop Disables roving analysis and removes the
monitor port from the roving analysis
configuration.
feature
broadcastStormControl
Enables and disables Broadcast Storm Control.
feature resilience
define
Creates a resilient link.
feature resilience
detail
Displays summary information about all resilient
links present in the stack.
feature resilience
remove
Deletes a resilient link.
feature resilience swap Swaps over the “active” resilient link.
feature trunk addPort Adds a single port to a trunk.
feature trunk detail Displays detailed information about the trunks
supported by the current Switch unit.
feature trunk removePort Removes a single port from a trunk on the
current Switch unit.
feature trunk summary Displays summary information about all trunks.
ip interface bootp Enables and disables BOOTP for the current
Switch unit in the stack.
ip interface define Specifies the IP information for the current
Switch unit in the stack.
ip interface display Displays the IP information for the current
Switch unit in the stack.
ip ping Allows you to ping other devices on your
network.
ip initializeConfig Allows you to reset the IP configuration back to
factory defaults. This command operates on the
whole stack.
snmp community Specifies SNMP community strings for the stack.
Table 8 Command line interface commands
Command What does it do?