Displaying switch administration details – 3Com 1100 User Manual
Page 143
Displaying and Changing Stack Information
143
Displaying Switch
Administration
Details
You can display the administration details for the current Switch unit in
the stack using the
display
command on the System menu. This
information may be useful for your technical support representative if you
have a problem.
To display the information:
■
From the Top-level menu, enter:
system display
The administration details are displayed.
An example of the details is shown below. Some fields are only displayed
after a software upgrade failure and these provide information about the
software upgrade.
The following read-only fields are displayed:
System Name
Displays the descriptive name, or system name, for the unit. For
information about assigning a new name, see
.
Location
Displays the physical location of the unit. For information about assigning
a new location, see
“Specifying Stack Administration Details”
on
.
Contact
Displays the details of a person to contact about the stack. For
3Com SuperStack II
System Name:
Development
Location:
Wiring Closet, Floor 1
Contact:
System Administrator
Time since reset:
2 days, 3 hours, 10 minutes
Operational Version:
2.20
Hardware Version
1
Boot Version:
1.00
MAC Address:
08:00:00:00:11:11
Product No.
3C33000
Serial Number
7ZNR001111
TFTP Server Address
161.71.120.152
Filename
s2s02_50.bin
Last software upgrade
TFTP Access Violation