3Com 1100 - Manual (Page 150)

150 C HAPTER 4: W ORKING W ITH THE C OMMAND L INE I NTERFACE
Modifying Access
Rights
You can modify access rights for the access levels in the stack using the
modify command on the System/Security/Access menu.
To modify the access rights for the stack:
1 From the Top-level menu, enter:
system security access modify
The following prompt is displayed:
Enter access level (monitor,manager,security):
2 Enter the access level to be modified.
The following prompt is displayed:
Enter new value for SNMP (enable,disable) [enable]:
3 Enter enable if the access level allows SNMP management, or disable if
it does not.
The following prompt is displayed:
Enter new value for console (enable,disable) [enable]:
4 Enter
enable
if the access level allows management through a console
port of the stack, or
disable
if it does not.
The following prompt is displayed:
Enter new value for telnet (enable,disable) [enable]:
5 Enter enable if the access level allows telnet management, or disable if
it does not.
The following prompt is displayed:
Enter new value for web (enable,disable) [enable]:
6 Enter
enable
if the access level allows web management, or
disable
if it
does not.
Enabling and
Disabling Remote
Access
As a basic security measure, you can enable or disable remote access to
the management software of the stack:
■
When remote access is enabled, you can access the management
software using all management methods.
■
When remote access is disabled:
■
Users cannot access the stack over the network using the
command line interface.