3Com 1100 - Manual (Page 141)

Displaying and Changing Stack Information 141
Displaying and
Changing Stack
Information You can display and change information about the Switch units in the
stack or the stack as a whole using the commands on the System menu.
These commands allow you to:
■
Move the focus of the command line interface from one Switch unit in
the stack to another
■
Specify administration details for the stack
■
Display administration details for the current Switch unit in the stack
■
Display summary information about the Switch units in the stack
■
Change the password for the current user
■
Specify, display, modify and remove user details for the stack
■
Display and modify the access rights for the access levels in the stack
■
Enable and disable all forms of remote access to the stack
■
Reset the Switch units in the stack
■
Initialize the Switch units in the stack
■
Upgrade the management software of the Switch units in the stack
■
Configure intelligent modules in the stack.
Moving the Focus of
the Command Line
Interface
Many commands in the command line interface perform their actions on
a single Switch unit in the stack — the current Switch. You can move the
focus of the command line interface from one unit in the stack to another
using the
unit
command on the System menu.
To move the focus:
1 At the Top-level menu, enter:
system unit
The following prompt is displayed, allowing you to enter a unit number:
Select unit [1]:
2 Enter the number of the unit to be managed.