3Com 3800 - Manual (Page 74)

4-20 C HAPTER 4: C OMMANDS
RIP Commands Table 4-17 describes the commands used to configure the RIP protocol.
Table 4-17 RIP Commands
Command Description
show rip {vlan | all} Displays RIP configuration and statistics for one or more
VLANs. Display includes the state for RIP settings, and
interface states. Statistics include the following:
■
Packets transmitted
■
Packets received
■
Bad packets received
■
Bad routes received
■
Number of RIP peers
■
Peer information
enable rip Allows you to enable RIP.
disable rip Allows you to disable RIP.
config rip add {vlan | all} Allows you to configure RIP on an IP interface. If no
VLAN is specified, then “all” is assumed. When an IP
interface is created, per interface RIP configuration is
enabled by default.
config rip delete {vlan | all} Allows you to disable RIP on an IP interface. When RIP
is disabled on the interface, the parameters are not
reset to their defaults.
enable rip aggregation Allows you to enable RIP aggregation of subnet
information on a RIP version 2 interface. The default
setting is enabled.
disable rip aggregation Allows you to disable the RIP aggregation of subnet
information on a RIP version 2 interface.
enable rip splithorizon Allows you to enable the split horizon algorithm for
RIP. Default setting is enabled.
disable rip splithorizon Allows you to disable split horizon.
enable rip poisonreverse Allows you to enable the split horizon with
poison-reverse algorithm for RIP. The default setting is
enabled.
disable rip poisonreverse Allows you to disable poison reverse.
enable rip triggerupdate Allows you to enable triggered updates. Triggered
updates are a mechanism for immediately notifying a
router’s neighbors when the router adds or deletes
routes, or changes the metric of a route. The default
setting is enabled.
disable rip triggerupdate Allows you to disable triggered updates.
(continued)
SW3800.BK Page 20 Tuesday, May 5, 1998 5:20 PM