3Com 3800 - Manual (Page 119)

Configuring DHCP/BOOTP Relay 8-7
Table 8-2 describes the commands used to configure the IP route table.
Table 8-3 describes the commands used to configure RIP.
clear ipfdb [ | vlan | all] Removes the dynamic entries in the IP
forwarding database.
Table 8-1 Basic IP Commands (continued)
Command Description
Table 8-2 Route Table Configuration Commands
Command Description
config iproute add
{}
Adds a static address to the routing table. Use a
value of 255.255.255.255 for “mask” to indicate a
host entry.
config iproute delete Deletes a static address from the routing table.
config iproute add blackhole Adds a blackhole address to the routing table. All
traffic destined for the configured IP address is
dropped, and no Internet Control Message Protocol
(ICMP) message is generated.
config iproute delete blackhole Deletes a blackhole address from the routing table.
config iproute add default
{}
Adds a default gateway to the routing table. A
default gateway must be located on a configured IP
interface . If no metric is specified, the default metric
of 1 is used.
config iproute delete default Deletes a default gateway from the routing table.
Table 8-3 RIP Configuration Commands
Command Description
enable rip Enables RIP. The default setting is disabled.
enable rip aggregation Enables RIP aggregation of subnet information on a RIP
version 2 interface. The default setting is enabled.
enable rip exportstatic Enables the advertisement of static routes using RIP. The
default setting is enabled.
enable rip poisonreverse Enables the split horizon with poison-reverse algorithm for
RIP. The default setting is enabled.
(continued)
SW3800.BK Page 7 Tuesday, May 5, 1998 5:20 PM