Xerox 4213 - Manual (Page 84)

XES COMMAND LANGUAGE MODE
Syntax
E tn1,n2,...,n160 L
t Instruction to set horizontal tabs.
n1,n2,..,n160 Tab settings across the page starting from the left
edge. Up to 160 tabs can be set in one command.
Commas separate values. See table 2-4 for default
horizontal tab values for portrait and landscape
pages.
L Line end.
Where to place it At the start of the job or anywhere a horizontal tab is desired.
Example Figures 2-7 and 2-8 show a line of tabs across an 216 by 279 mm
portrait page. Figure 2-7 shows the settings in units of five pixels
(1/60 inches). Figure 2-8 shows the same settings in units of one
pixel (1/300 inches).
More Up to 160 horizontal tabs may be set per job. If you try to set
more, the printer will consider all tabs to the right of the last tab
setting as spaces. This will affect the appearance of the page.
Table 2-4. Default values for horizontal tabs
Position
U.S.
portrait U.S.
landscape International
portrait International
landscape
1st tab 1.1 inch
28 mm
330 dots 1.1 inch
28 mm
330 dots 1.04 inch
26.4 mm
313 dots 1.04 inch
26.4 mm
313 dots
Intervals 0.44 inch
11.2 mm
132dots 0.44 inches
11.2 mm
132 dots 0.48 inches
12.2 mm
144 dots 0.48 inches
12.2 mm
144 dots
2-46 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE