Xerox 4213 - Manual (Page 226)

POSTSCRIPT EMULATION
After the server has acknowledged the exit request, you are
permitted to run a programme using statusdict operators that
change persistent parameters. Operators that set persistent
parameters are marked with an asterisk. To change these
parameters, you must first exit the normal server mode. You can
inquire about the current state of persistent parameters without
using the exitserver mode, and accessing statusdict only.
Parameters that remain in effect for the current job only can also
be changed via statusdict only.
System set up operators
pagecount —pagecount integer
This operator returns the number of pages the controller has
generated. It reflects the pages generated in all emulations, not
just the Postscript emulation.
setprintername* string setprintername—
printername string printername substring
String represents the printer's name and is printed on the
configuration sheet. The name can be up to 32 characters long
and should consist of printable characters. Avoid using the
characters (:) or (@).
setsccinteractive* —channel baud options setsccinteractive
sccinteractive —channel baud options sccinteractive
Because communications options can be selected through the
User Interface, the operator setsccinteractive is ignored by the
PDL interpreter in the printer. The operator sccinteractive
reports the current communications options to the host.
setsccbatch* channel baud options setsccbatch —
sccbatch channel sccbatch baud options
The printer ignores the setsccbatch operator because the user
can select the communications options through the User
Interface. The sccbatch operator always returns the active
communications options on the printer.
4-4 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE