Xerox 4213 User Manual
Page 35
INTERFACES
Set flow control
With parity options appearing on the User Interface, follow these
steps:
1. Press the Menu
A
button.
2. Press the Last Page
C
button until FLOW CONTROL appears.
3. Press the Test
B
button.
4. Press the Last Page
C
button to scroll through the two flow
control choices: XON/OFF, DTR.
4. Press the Select
D
button to enter your choice.
Note:
When connected to a modem, XON/OFF is required.
Return to printer operation
Press the Online
H
button to return the 4213 to Print Mode.
RS232 (serial) connector
The 4213 supports asynchronous modems and host employing
the RS232C interface. The modems supported are Bell 103 and
212 compatible asynchronous modes communicating at rates of
1,200, 2,400, 4,800, 9,600, or 19,200 bps, half or full 2-sided.
The printer is connected to a modem via a cable with a Cannon
or Cinch DB-25P connector attached.
Figure 1-5 shows the RS232C connector.
Figure 1-5.
RS232C (serial) connector
Note
Maximum length for the serial interface cable is 15
metres (50 feet).
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
1-13