Xerox 4213 - Manual (Page 184)

LJ SERIES 2D EMULATION
The text length is set to the user default whenever the page
orientation, length, size, or top margin is changed. The user
default is calculated as the quotient (integer) of the following
equation:
(Printable Area Length-TopMargin- )48 ÷ VMI
where Printable Area Length and Top Margin are measured in
inches.
Syntax
E
&l#F
where
#
is the number of lines of text required.
Example To set a text length of 55 lines, enter:
E &l55F
Hex 1B 26 6C 35 35 46
Dec 27 38 108 53 53 70
Perforation Region
Purpose The Perforation Region command determines the action of the
printer when text is positioned below the bottom line of text
defined by the Text Length command. When the Perforation
Region is enabled, text which would fall below the bottom line
specified by the Text Length command is moved automatically to
the top of the text area on the next page.
When Perforation Region is not enabled, text may extend
beyond the bottom of the text area and may not be printed if it
continues out of the printable area. The default setting is
Perforation Region enabled. The size of the perforation region
depends on the dimensions specified by the Page Size and Page
Length commands.
Syntax
E &l#L
where # = 0 disables Perforation Region
# = 1 enables Perforation Region.
3-24 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE