Xerox 4213 - Manual (Page 30)

INTERFACES
4. Press the Test B button.
5. Press the Last Page C button until PARALLEL DPROD appears.
6. Press the Select D button to select Dataproducts parallel.
Dataproducts connector
The use of a pigtail conversion cable provides compatibility with
the Dataproducts 2260 line printer controllers. The Dataproducts
interface uses a 50-pin Winchester connector # MRA S D5J,
which mates with a Winchester MRAC 50 P JKTCH connector,
using 100 1020P pins. The pin names are provided in this figure
only for the sake of information. They do not appear on the real
connector. The maximum cable length when using the
Dataproducts interface is 10 feet (3.05 metres). Figure 1-3 shows
the Dataproducts connector.
The 4213 does not support Negative Logic mode for
Dataproducts 2260.
Figure 1-3. Dataproducts interface connector
1-8 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE