Xerox 4213 - Manual (Page 209)

LJ SERIES 2D EMULATION
Syntax
E )s#W[font descriptor + data]
Hex 1B 29 73 # 57
Dec 27 41 115 # 87
where # is the number of bytes in the font descriptor that
follows. (The brackets are not to be entered.) The font
descriptor is normally 64 bytes long.
The font descriptor contains values for the following font
characteristics:
• font type
• baseline distance
• cell width
• cell height
• orientation
• fixed/proportional spacing
• symbol set
• pitch
• height
• style
• stroke weight
• typeface.
For information on how to format a font descriptor block refer to
the Hewlett-Packard Laser Printer Technical Reference Manual.
Character Code
Purpose The Character Code command specifies the decimal ASCII value
of the next character to be downloaded.
Syntax
E *c#E
where # is the single-byte decimal character code.
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 3-49