Xerox 4213 - Manual (Page 139)

XES COMMAND LANGUAGE MODE
• The last command, Graphic Fill, selects pattern 7 and defines
one seed point in the closed figure made by the line and two
sides of the rectangle. Shown in the figure is the seed point
location, at coordinates 170,250.
E gw1,2;,,300,300 L
E gb5;3,3,297,297 L
E gl;3,3,100,250,150,200,200,200,250,150,297,297 L
E gf7;170,250 L
Figure 2-32. Fill pattern bounded by a graphic figure
More If 0 for a user-defined pattern is entered for P, the fill pattern
data is entered after the line end of the Graphic Fill command.
User-defined data must be sixel encoded. Refer to appendix C
for information on sixel encoding.
You cannot fill an area with more than one pattern.
A fill must start in a closed figure, that is, one surrounded by
printed lines. However, the edge of the window can also serve as
a boundary for a fill.
The edge of the page cannot serve as a boundary for a fill.
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 2-101