Xerox 4213 - Manual (Page 39)

2. XES command language mode
This chapter is for anyone using the Xerox Escape Sequence (XES)
emulation on the Xerox 4213 laser printer.
Configuring the 4213 for the XES command language mode
Please refer to the Xerox 4213 Laser Printer User Guide for
instructions on how to configure the 4213 printer to operate in
XES mode.
Automatic mode switching
It is possible to have software loaded in the 4213 which enables
you to switch from one emulation to another without
reconfiguring the printer. This requires the use of the mode
change command and the reset command.
Be careful to copy the commands exactly as they appear,
including uppercase letters, punctuation, and spaces. The
symbol
L represents a carriage return (ASCII 13 or 0DH), line
feed (ASCII 10 or 0AH), or both, depending on your computer
system.
In the IBM PC Disk Operating System (DOS), carriage return and
line feed are automatically entered when you press the Return
key at the end of each line.
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 2-1