Xerox 4213 - Manual (Page 220)

LJ SERIES 2D EMULATION
Macro commands
Macros are single commands that execute a series of commands
in sequence. The two Macro commands are:
• Macro ID
• Macro Control.
Macro ID
Purpose The Macro ID command provides an ID number for the following
macro commands. The ID number may be in the range 0 through
32767.
Syntax
E &f#Y
Hex 1B 26 66 # 59
Dec 27 38 102 # 89
where # is the value of the macro ID number used.
Macro Control
Purpose The Macro Control command can define, delete, and execute
macros.
Syntax
E &f#X
Hex 1B 26 66 # 58
Dec 27 38 102 # 88
where # is a value shown in table 3-15.
Notes • A temporary macro is automatically deleted during a printer
reset. The temporary macro is the default.
• A permanent macro is not deleted during a printer reset.
3-60 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE