Xerox 4213 - Manual (Page 56)

XES COMMAND LANGUAGE MODE
More Once the printer receives the Reset command, all parameters set
by the other commands are cancelled, including font indexes and
the UDK.
Using a Print Job rather than a Reset command to end one
document and start the next instructs the printer to continue
using all parameters entered during previous jobs.
Formatting the printed output
The commands discussed in this section determine the
formatting of the job’s printed output—how many copies will be
printed, which paper tray you will print from, whether the
document is 1-sided or 2-sided, and so on. These commands
are:
— Print Multiple Copies
— Print Multiple Copies (Non-Collated)
— Paper Tray
— Bypass Slot Paper Size
— Offset
— 2-sided Start
— 2-sided Invert Start
— 2-sided Stop
— 2-sided Side Select.
You do not need the commands unless you want settings that
are different from the defaults.
Also covered in this section is:
— Comment, which allows you to make notes in your job
without their appearing in the printed output or otherwise
affecting the job.
2–18 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE