Xerox 4213 - Manual (Page 196)

LJ SERIES 2D EMULATION
• Stroke weight
• Typeface
• Soft font with the lowest ID number
• Left cartridge
• Right cartridge
• Internal font orientation.
Font selection can only be guaranteed if the total set of font
commands shown on the following pages is used. Failure to
specify any of the font characteristics may result in selection of a
font that differs from the HP font.
Symbol Set
Purpose The Symbol Set command sends the printer a numeric code
corresponding to a symbol set. If a non-existent symbol set is
selected, the printer continues to use the last symbol set
accessed. There are separate Symbol Set commands for the
primary and secondary fonts.
Syntax
E (ID
The secondary font symbol set command is:
E
)ID
where ID is one of the two-character symbol set ID’s given in
table 3-8.
Example To use ISO25: French for the primary symbol set and ISO4:
United Kingdom for the secondary symbol set, enter the
following commands:
E (0F
Hex 1B 28 30 46
Dec 27 40 48 70
and
E )1E
Hex 1B 29 31 45
Dec 27 41 49 69
3-36 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE