Xerox 4213 - Manual (Page 156)

XES COMMAND LANGUAGE MODE
The last determination to be made is the record type. Since ISO
characters are to be used in this table, either “3” or “4” is
appropriate. The entire file then becomes:
E +T L
S40D00B8A3005D00A5005F00A800FF L
The components of this table record are shown in figure 2-37.
Figure 2-37. Completed table download record
Invoking the base table
Before sending the table data file to the printer, ensure to invoke
the mapping table that is to serve as the base table.
When the printer receives the Character Reassignment command,
it creates a new table by laying the new data over the mapping
table that is currently in effect. Locations not specified in the
table data remain the same in the new table as in the original
table over which it was laid. (See figure 2-38.) In this example,
the new data in the example discussed above is laid over the
U.S. English table. The new table is illustrated in table 2-8.
2-118 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE