Zoom ADSL X6v - Manual (Page 99)

Here is a picture of the Static Routes page:
The following table describes Routing Table settings. If you change
any of the settings, click Add, and then Write Settings to Flash.
Setting Description
Existing Routes This table shows the existing Static
routes set up on your ADSL Modem.
Destination Enter the Subnet IP address of the
destination.
Gateway Enter the Gateway IP address of your
destination’s subnet. The HOP gateway
must be on the same subnet as the
modem.
Mask Enter the subnet mask (range of IP
addresses) of the destination IP
addresses based on the above subnet IP
address of the destination.
Metric The number of hops. This should
usually be left at 1.
Advertise Enable this if you want to advertise this
route.
Chapter 6: Using Router Setup 99