ZyXEL Communications Prestige 28641 - Manual (Page 83)

Dial-In Configuration 69
3. Password - Enter the password for the Remote Dial-in User.
4. Callback - This field determines if the Prestige will allow call back
to the Remote Dial-in User upon dial-in. If this option is enabled,
the Prestige will be able to call back to the Remote Dial-in User if
they request it. In such a case, the Prestige will disconnect the initial
call from this user and dial back to the specified call back number
(see below). The default is no callback.
5. Callback # Supplied by Caller - If Callback is Yes, then this is a
required field. Otherwise, an N/A will appear in the field. Enter the
telephone number to which the Prestige will call back.
6. Callback Phone # - If Callback is No, an N/A will appear in the
field. The callback override allows the Remote Dial-in User to
specify the call back telephone number on call-by-call basis. This is
useful for when the Prestige returns a call back to a mobile user at
different numbers, e.g., a sales rep in a hotel. Note that the default is
No, i.e., the Prestige always calls back to the fixed callback
number.
7. Rem CLID - If you have enabled the CLID Authen field in Menu
13, then you need to specify the telephone number from which this
Remote Dial-in User calls. The Prestige will check this number
against the CLID in the incoming call. If they do not match and the
CLID Authen is Required, then the Prestige will reject the call.
8. Idle Time -out - Enter the idle time (in seconds). This time-out
determines how long the dial-in user can be idle before the Prestige
disconnects the call. Idle time is defined as the period of time where
there is no data traffic between the dial-in user and the Prestige. The
default is 300 seconds (5 minutes).
Once you have completed filling in Menu 14.1 - Edit Dial-in User ,
press ENTER at the message: Press ENTER to Confirm ... to save
your selections, or press ESC at any time to cancel your selections.