ZyXEL Communications Prestige 28641 - Manual (Page 26)

12 Before You Begin
management protocol and will be displayed as the prompt when the
user enters the Command Mode.
•
Route IP Field - For Internet access, you will need to enable the
Route IP Field. See Chapter 4 for more details on configuring your
Prestige for Internet access. To support Novell IPX, or Bridging,
enable the appropriate protocol and reference the related chapters
for detailed information.
You have now collected all of the general setup information you need.
Make sure that you have entered all the values onto the worksheet
before proceeding to the next section.
Collecting ISDN Phone Line Information
After you have successfully installed the ISDN phone line or if you
already have one installed, you need to use the ISDN line information to
complete the worksheet and configure your Prestige. Your telephone
company can give you the following information to configure the
Prestige:
Switch Type Geography No of Phone #s No of SPIDs
AT&T 5ESS NI-1 North America 2 2
AT&T 5ESS Point to Point North America 1 0
AT&T 5ESS Multipoint North America 2 2
Northern Telecom NI-1 North America 2 2
Northern Telecom Custom North America 2 2
DSS1 Europe, Asia 2 N/A
1TR6 Germany 2 N/A
•
Switch Type - This is the type of switch used by your telephone
company. Check with your telephone company and choose the
appropriate option on the worksheet. For North America, select
your ISDN switch type. For DSS1 and 1TR6, verify this field to
make sure that you have the proper firmware loaded.