ZyXEL Communications Prestige 28641 - Manual (Page 119)

Filter Configuration 105
Figure 10-6 Menu 21.1.3 - IPX Filter Rule
1. IPX Packet Type - Enter the IPX packet type value of the packet
you wish to filter. This value should be two hex-bytes.
2. Destination/Source Network # - Enter the four hex-byte
destination/source network numbers of the packet that you wish to
filter.
3. Destination/Source Node # - Enter in the six hex-byte value for
the destination/source node number of the packet you wish to filter.
4. Destination/Source Socket # - Enter the destination/source
socket number of the packets that you wish to filter. This should be
a 4-byte hex value.
5. Destination/Source Socket # Comp - You can select what
comparison quantifier you wish to use to compare to the value given
in Destination Socket # and Source Socket #.
6. Operation - This field is only active if one of the Socket # fields is
0452 or 0453 indicating SAP and RIP packets. There are seven
options for this field which determines the operation for the IPX
packet.
•
None.