ZyXEL Communications Prestige 28641 - Manual (Page 38)

24 Installation
connectors that look like a bigger telephone plug with 8 pins. Two types
of gray Ethernet cables come with the package:
•
Straight through cable (white tag): Connect your Prestige to a
10Base-T hub.
•
Crossover cable (red tag): Connect your Prestige to your
computer directly without a hub.
O N
OTE
: I
F THIS CABLE IS USED TO CONNECT
ISDN,
IT MAY DAMAGE YOUR
P
RESTIGE
.
•
AUI
The AUI port (the connector with 15 pins) is used to connect the
Prestige to a 10Base5 (thicknet) network.
If you have a 10Base2 network using BNC connectors and thin coaxial
cables, you will need a transceiver between the AUI port and the
10Base2 cabling.
Connecting a Power Adapter to your Prestige
Plug a 16VAC 1200mA power adapter into the outlet on the rear panel
of the Prestige labeled POWER
At this point, you should have connected the RS-232 cable, the ISDN
phone line, the Ethernet cable, and the power supply. You can now
power on your Prestige.
Prestige Front Panel
Names and descriptions of the Prestige front panel LEDs are listed
below: