ZyXEL Communications Prestige 28641 - Manual (Page 36)

22 Installation
A Warning On Connection Cables
The RS-232, ISDN line, and Ethernet cable, are very similar to each
other. It is important that you use the correct cable for each connection;
otherwise, your Prestige could be damaged.
Connecting Your Computer and Your Prestige
For the initial setup of your Prestige, you must use an RS-232 cable and
communications software to configure the Prestige.
After the Prestige has been successfully installed, you can modify the
configuration through a remote Telnet connection. See Chapter 13 for
detailed instructions on using Telnet to configure your Prestige.
Connecting the RS-232 Cable to your Prestige
To connect the RS-232 cable, first click open the door on the right
panel to reveal the port. Plug one end of the RS-232 cable (looks like a
telephone jack) into the port until the retainer clicks into place. Connect
the other end of the RS-232 cable to the serial port (COM1, COM2,
or any other COM port) of your computer.
Connecting an ISDN Line to your Prestige
Plug one end of your ISDN phone line which is included in your
package into the socket on the rear panel of the Prestige labeled ISDN
and the other end into the ISDN wall jack.
•
S/T interface - This can only connect to your NT-1 (Network
Termination) device.
O N
OTE
: D
O NOT UNDER ANY CIRCUMSTANCES CONNECT DIRECTLY TO THE
ISDN
WALL
JACK
.