ZyXEL Communications LAYER 3 ES-3124 - Manual (Page 293)

ES-3124 User’s Guide
Chapter 37 Interface Commands 291
Syntax:
bandwidth-limit
bandwidth-limit pir
bandwidth-limit cir
bandwidth-limit egress
where
An example is shown next.
• Enable port one for configuration.
• Enable bandwidth control.
• Set the outgoing traffic bandwidth limit to 5000Kbps.
• Set the guaranteed bandwidth allowed for incoming traffic to 4000Kbps.
• Set the maximum bandwidth allowed for incoming traffic to 8000Kbps.
37.2.5 mirror
The mirror command enables port mirroring on the interface.
Syntax:
mirror
mirror dir
where
An example is shown next.
pir = Sets the maximum bandwidth allowed for incoming traffic.
cir = Sets the guaranteed bandwidth allowed for incoming traffic.
egress = Sets the maximum bandwidth allowed for outgoing traffic
(egress) on the switch.
ras(config)# interface port-channel 1
ras(config-interface)# bandwidth-limit
ras(config-interface)# bandwidth-limit egress 5000
ras(config-interface)# bandwidth-limit cir 4000
ras(config-interface)# bandwidth-limit pir 8000
dir
= Enables port mirroring for incoming, outgoing or both
incoming and outgoing traffic.
Port mirroring copies traffic from one or all ports to another
or all ports for external analysis.