ZyXEL Communications LAYER 3 ES-3124 - Manual (Page 263)

ES-3124 User’s Guide
Chapter 34 Introducing Commands 261
multicast-limit Enables the interface multicast
limit.
13
Sets how many multicast packets
the interface receives per second.
13
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
13
Sets the interface DLF limit in
packets per second (pps).
13
diffserv Enables DiffServ on the port(s). 13
qos priority <0 .. 7> Sets the quality of service priority
for an interface.
13
mirror Enables port mirroring in the
interface.
13
dir
|both>
Enables port mirroring for
incoming, outgoing or both
incoming and outgoing traffic.
Port mirroring copies traffic from
one or all ports to another or all
ports for external analysis.
13
speed-duplex
half|10-
full|100-
half|100-
full|1000-full>
Sets the duplex mode ( half or
full ) and speed ( 10 , 100 or
1000 Mbps) of the connection on
the interface. Selecting auto
(auto-negotiation) makes one port
able to negotiate with a peer
automatically to obtain the
connection speed and duplex
mode that both ends support.
13
bpdu-control
scard|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
13
no egress set Disables the outgoing traffic port
list for a port-based VLAN.
13
protocol-based-
vlan ethernet-
type
type>
Disables protocol based VLAN of
the specifed protocol on the port.
13
igmp-immediate-
leave
Disables IGMP immediate leave on
the port.
13
igmp-filtering
profile
Disables IGMP filtering on the port. 13
igmp-group-
limited
Disables IGMP group limitation. 13
ingress-check Disables ingress checking on the
port(s).
13
gvrp Disable GVRP on the port(s). 13
flow-control Disables flow control on the port(s). 13
Table 85 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE