ZyXEL Communications Omni 56K II User Manual
Page 79
Omni 56K II and Omni 56K Plus II User’s Guide
Command Sets
5-33
COMMAND BIT DEC HEX
FUNCTION
AND
DESCRIPTION
REF.
7
128
80
Ignore calling tone, not to be used as fax detection.
bit dec hex Bit-mapped
register.
1 2 2 Enables
throughput
averaging.
2
2
4
4
A CND message forces on even if ATQ2 is set.
3
8
8
This disables the escape sequence code in answer
mode.
4
16
10
This disables the V.17 14,400 Fax in calling mode and
no effect on answering mode.
6
64
40
This disables the 'RINGING' result code.
Xn
S42=
7
128
80
The DCD is forced on but pulses off for 0.5 second at
carrier loss.
&C0
bit dec hex Bit-mapped
register.
+008
6
64
40
Enable a 1.5 second pause between off-hook and
modem answering.
S43=
7
128
80
The modem hangs-up if the line condition does not
permit the modem to run at the highest speed set by
'&Nn' command.
bit dec hex Bit-mapped
register.
+000
3 8 8 ATDSn
initiates
auto-dial of the stored numbers
consecutively until a connection is made (cyclic dial).
DSn
4
16
10
DSR follows DTR (see also S41.5).
&S1
S44=
6
64
40
When selected with ‘&B0’, DTE speed is fixed at
38400 when the link speed is above 9600. DTE speed
is fixed at 9600 if the link speed is 7200. If it is below
7200, the DTE speed follows link speed. When
selected with &B1, DTE speed is fixed at the current
rate when an ARQ connection is made. When a non-
ARQ connection is made, DTE speed follows the link
speed (See also S18).
&Bn
S45= dec
0-255
hex
0-FF
The delay during which the CND silence detection is
disabled, in 20 ms units (see also S46).
+100
S46=
dec
hex
The CND silence detection interval.
+028