ZyXEL Communications Omni 56K II - Manual (Page 62)

Omni 56K II and Omni 56K Plus II User’s Guide
5-16 Command Sets
COMMAND DESCRIPTION VALUE
Indicates that a document is available for polling. n=1
+FMDL? Request the DCE model.
+FMFR? Request the DCE manufacturer.
+FMINSP=n Minimum phase C speed parameter.
2400 bps. n=0
4800 bps. n=1
7200 bps. n=2
9600 bps. n=3
12000 bps. n=4
14400 bps. n=5
+FPHCTO=
DTE Phase C response time-out:
Determines how long the DCE will wait for a command after reaching the
end of data when transmitting in Phase C.
=0 to 255; 100 ms units. 0-255
+FPTS=n Page transfer status
Received page status - good. n=1
Received page status - bad; retrain requested. n=2
Received page status - good; retrain requested. n=3
Received page status - bad; procedure interrupt requested. n=4
Received page status - good; procedure interrupt requested. n=5
+FREL=n Phase C received EOL alignment:
The EOL patterns are bit aligned as received. n=0
The last received bits of EOL patterns are byte aligned by the DCE, with
necessary zero fill bits inserted. Refer to TIA PN-2388 for details. n=1
+FREV? Request the DCE revision identification.
+FSPL=n "Enable polling" command:
Disable polling. n=0
Enable polling. n=1