ZyXEL Communications Omni 56K II - Manual (Page 77)

Omni 56K II and Omni 56K Plus II User’s Guide
Command Sets 5-31
COMMAND BIT DEC HEX FUNCTION AND DESCRIPTION REF.
40 28 Reserved
6-7 Signal quality.
0 0 No response to poor signal quality. *Q0
64 40 Retrain action taken if signal quality is poor. *Q1
128 80 Adaptive rate (auto fall-back/forward) when signal
quality changes (default). *Q2
192 C0 Disconnect when signal quality is poor. *Q3
bit dec hex +068
2-3 0 0 Destructive, expedited break. &Y0
1 4 Non-destructive, expedited break (default). &Y1
10 8 Non-destructive, un-expedited break. &Y2
4-5 0 0 No guard tone (default). &G0
16 10 550 Hz guard tone. &G1
32 20 1800 Hz guard tone. &G2
6 0 0 The DTE/DCE rate follows link rate (see also s18,
S44b6) &B0
S28=
1 64 The DTE/DCE rate is fixed at the DTE setting, range
from 300-460.8 Kbps (default, also see S18, S44b6)
S29= 0 to 3 0 to 3 Sets the default dial phone number pointer, use
AT&Zn=s to store phone numbers in the Windows
registry. +000 *D
S31= 0-255 0-FF Holds the ASCII decimal value of the XON +017
S32= 0-255 0-FF Holds the ASCII decimal value of the XOFF +019
bit dec hex Bit-mapped register. +032
1 2 2 Disables aborting from the terminal during modem
handshaking.
3 8 8 Add 16dB attenuation to the leased line transmission
power.
S35=
5 32 20 Enable Selective Reject in V.42 (default).