ZyXEL Communications Omni 56K II - Manual (Page 49)

Omni 56K II and Omni 56K Plus II User’s Guide
Command Sets 5-3
COMMAND OPTIONS FUNCTION & DESCRIPTION REF.
I2 Displays the modem link status report.
I12 Displays the physical layer status.
I13 Displays the channel response for V.34
Ln n=0-7 4 * Speaker volume control. The higher the value, the
higher the volume. S24.4-6
Speaker control S21.1-2
M0 The speaker is always OFF.
M1 * The speaker is ON until carrier detected.
M2 The speaker is always ON.
Mn
M3 The speaker is ON after the last digit is dialed out
Tone dialing is not heard.
O Returns to online state.
O1 Force the modem to request a retrain.
Displays the result code displayed. S23.7
Q0 * The modem returns the result code.
Q1 The modem does not return the result code.
Qn
Q2 The modem returns the result code but is quiet
after answering on a RING. (see also S42.2) S40.1
Sr.b=n Sets bit 'b' of S-register 'r' to value 'n'. 'n' is a binary
digit '0' or '1'.
Sr.b? Displays the value of bit 'b' of S-register 'r'
Sr=n Sets S-register 'r' to value 'n'. 'n' must be a decimal
number between 0 and 255.
Sr? Displays the value stored in S-register 'r'
T Tone dial S23.1
UPX Download firmware to the Flash EPROM by using
Xmodem protocol.
Sets the display type for result codes. S23.6 Vn
V0 Displays the result code in numeric form. (See also
S35.7 and the result code table of 'ATXn')