beautypg.com

S-register descriptions, 6 s-register descriptions, 1 basic s-registers "atsn=x – ZyXEL Communications Omni 56K II User Manual

Page 71

background image

Omni 56K II and Omni 56K Plus II User’s Guide

Command Sets

5-25

RESPONSE CODE

DESCRIPTION

u

Transmission Buffer Underrun. The DCE reports this code if the DEC’s buffer
becomes empty without first receiving a command.

End of stream

5.6 S-Register

Descriptions

In most bit-mapped S-registers, the default bit value is 0. An asterisk follows non-0 default values. In some
cases, default values are shown in the reference column preceded by +. Some bits are reserved for factory use
and should not be changed.

5.6.1

Basic S-Registers "ATSn=x"

Table 5-15 Basic S-Registers "ATSn=x"

COMMAND

FUNCTION & DESCRIPTION

REF.

S0=

Sets the number of rings on which the modem will answer. A value of 0 disables
auto-answering.

+000

S1=

Counts and stores the number of rings from an incoming call.

+000

S2=

Defines the escape code character, default ' +' (43 dec.). A value of 128-255 disables
the escape code.

+043

S3=

Defines the ASCII Carriage Return.

+013

S4=

Defines the ASCII Line Feed.

+010

S5=

Defines the ASCII Backspace key. A value of 128-255 disables the Backspace key' s
delete function.

+008

S6=

Sets the number of seconds the modem waits before dialing if ' X0' or ' X1' is
selected. If a setting of ' X2,' 'X7' is selected; the modem will dial as soon as it detects
a dial tone. This register also sets the time-out interval for the "W" dial modifier to
wait for the dial tone. (See also S41b4)

+003

S7=

Sets duration, in number of seconds modem waits for a carrier.

+060

S8=

Sets duration, in seconds, for pause (,) option in Dial command and pause between
command re-executions for Repeat (>) command.

+002

S9=

Sets duration, in tenths of a second of remote carrier signal before recognition.
(Ignored if in non-FSK or half-duplex operation)

+006

S10=

Sets duration, in tenths of a second, that the modem waits after the carrier is lost
before hanging up.

+007

This manual is related to the following products: