beautypg.com

ZyXEL Communications Omni 56K II User Manual

Page 66

background image

Omni 56K II and Omni 56K Plus II User’s Guide

5-20

Command

Sets

COMMAND DESCRIPTION

VALUE

+FNR=rpr,tpr,idr,nsr

Enable Negotiation Reporting

rpr= 0:Receiver parameters are
not reported.
rpr=1:Receiver parameters are
reported.
tpr= 0:Transmitter parameters
are not reported.
tpr=1:Transmitter parameters
are reported.
idr= 0: ID Strings are not
reported.
idr=1: ID Strings are reported.
nsr= 0:Non-standard frames
are not reported.
nsr= 1:Non-standard frames
are reported.

+FIE=n

Procedure Interrupt parameter

n=0:Disable
n=1:Enable

+FPS=n

Page Transfer Status

n=1:Received page is good.
n=2:Page is bad; retrain is
requested.
n=3:Page is good; retrain is
requested.
n=4:Page is bad; procedure
interrupt is requested.
n=5:Page is good; procedure
interrupt is requested.

+FLO=n

Flow Control Select

n=0:No flow control
n=1:Sets XON/ XOFF software
flow control
n=2:Sets CTS/RTS hardware
flow control

+FPR=n

Serial Port Rate Control n=0:Automatic

DTE

rate

detection by the DCE
n>0:Serial rate is fixed at the
value multiplied by 2400 bps.

+FBO=n

Phase C Data Bit Order

n=0:Selects direct bit order
n=1:Selects reversed bit order

+FEA=n

Phase C Received EOL alignment

n=0:EOL patterns are as
received

This manual is related to the following products: